AP10 40 Polyurethane Elastomer. With a shore A hardness of around 40, this elastomer is very useful. It can be cast in sections to produce midly flexible items and has been successfully used to replicate harder rubbers often found in bushes and mounts for automotive. Got a bush you can't buy? Simple. Grab some RTV silicone and this product and make your own!

Also a tough moulding compound, suited to cementious mixes though this is a little soft for impression pads, but for smaller pieces may be ok.

LOW Linear Shinkage, excellent tear strength and wear resistance.

Pot Life 20-40 mins, Full Cure 72-96 hours, Hardness at full cure Shore A 35-45. Measurements and timings assumes a 100g mix at 25 celsius.

Should you need larger volumes, rather than a larger kit we offer dscounts on multiples. 5% discount on 5 kits purchased, 10% discount on 10+ kits purchased.