RTV Block Mould
How to make a single piece RTV Silicone Mould. Probably the easiest mould to make with RTV using either Addition or Condensation Cure Silicone. In simple step by step format with pictures to assist.
To complete this project you will need RTV Silicone, click the picture to read more.
RTV Sectional Mould
How to make a Split or Sectional RTV Silicone Mould. Probably the next easiest mould to make with after the block mould, using either Addition or Condensation Cure Silicone.
In simple step by step format with pictures to assist. To complete this project you will need RTV Silicone, click the picture to read more.
RTV Skin Mould
How to make a Skin or Blanket RTV Silicone Mould. Probably the next easiest mould to make with after the block mould, using either Addition or Condensation Cure Silicone.
In simple step by step format however this article has no pictures yet.
To complete this project you will need RTV Silicone, click the picture to read more.
GRP Single Piece Mould
How to make a Single Piece GRP Fibreglass Mould. These are fully rigid and will not tolerate any undercuts
In simple step by step format however this article has no pictures yet. To complete this project you will need various GRP Products, click the picture to read more.
GRP Sectional Mould
How to make a Sectional Piece GRP Fibreglass Mould. These are fully rigid and will not tolerate any undercuts in any of the sectional parts
In simple step by step format however this article has no pictures yet. To complete this project you will need various GRP Products, click the picture to read more.
Vinamold Moulds
How to make a Vinmold Mould. These are heat formed fleixble tools with variation of hardness available from the material choice. You will need Vinamold to complete your project. Click the picture to read more.
Latex Mould
How to make a Latex Sock Mould. Used extensively in garden ornament moulds, latex is low cost, easy to use if a little slow to apply.
In simple step by step format with pictures. You will need Latex to complete this project. click the picture to read more.
Support Cases
How to make a Support Cases. Used to support thin walled moulds like latex or rtv skin moulds and prevent distortion.
In simple step by step format, sadly no pictures as yet. You may require GRP or Plaster with Jute Scrim to complete this project. Click the picture to the left to get started.
